Cisco Nexus 6000 Series NX-OS FabricPath Command Reference
T Commands
Downloads: This chapterpdf (PDF - 78.0KB) The complete bookPDF (PDF - 806.0KB) | Feedback

T Commands

Table Of Contents

T Commands

topology


T Commands


This chapter describes the Cisco NX-OS FabricPath commands that begin with T.

topology

To configure a Layer 2 topology for FabricPath Intermediate System-to-Intermediate System (ISIS), use the topology command. To return to the default setting, use the no form of this command.


Note The Cisco Nexus switch supports only two topologies; the default or base topology (topology 0), and another optional topology (for example, topology 1).


topology topology-number

no topology [topology-number]

Syntax Description

topology-number

Topology number. The range is form 1 to 63.


Command Default

None

Command Modes

FabricPath IS-IS configuration mode

Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.


Usage Guidelines

This command requires an Enhanced Layer 2 license.

Examples

This example shows how to configure a FabricPath IS-IS topology:

switch# configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# topology 1
switch(config-fabricpath-isis)#

Related Commands

Command
Description

fabricpath domain default

Enables FabricPath Layer 2 IS-IS.