The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS FabricPath commands that begin with H.
To configure a dynamic hostname exchange for Intermediate-System-to-Intermediate System (IS-IS), use the hostname dynamic command. To return to the default setting, use the no form of this command.
hostname dynamic
no hostname dynamic
This command has no arguments or keywords.
ON
FabricPath IS-IS configuration mode
|
|
---|---|
6.0(2)N1(1) |
This command was introduced. |
This command requires an Enhanced Layer 2 license.
This example shows how to configure a dynamic hostname exchange for IS-IS:
switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fabricpath domain default
switch(config-fabricpath-isis)# hostname dynamic
switch(config-fabricpath-isis)#
|
|
---|---|
show hostname |
Displays the system's hostname. |