The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Off—There is no hard drive in the hard drive sled. Green—If steady, the hard drive is ready. If blinking, the hard drive is reading or writing data. |
||
Off—The appliance is powered off or in standby power mode. Green, blinking—Communicating with network, main power mode. Blink rate increases with activity. |
||
Green—The appliance is operating properly. Amber, blinking—Requires service. Investigate other LEDs and check logs to isolate the problem. |
||
Off—The Locator LED is not in use. Blue, flashing—The front LED/button was pressed, flashes front and rear to help find appliance in rack. |
||
Green—If blinking, in standby power mode. If steady, in main power mode. See the Connecting the Power Cable. |
Off—No AC power is present in any power supplies. Green—This power supply is operating properly in main power mode. Green, blinking—This power supply is operating properly in standby power mode. Amber, flashing—There is no AC power present in this power supply. Amber and Green, blinking—Warning over-temperature condition: 176 °F (80 °C). Auto recovery when the temperature is less than 167 °F (75 °C). Amber—Power supply failure. Critical shutdown over 194 °F (90 °C). Auto recovery when the temperature is less than 167 °F (75 °C). See the Connecting the Power Cable. |
||
Off—The Locator LED is not in use. Blue, flashing—The front LED/button was pressed, flashes front and rear to help find the appliance in rack. |
||
10/100 Ethernet link status1 |
Read both link status and speed for the following: Link status off + speed off—No link is present on this port. Link status off + speed solid green—A half-duplex, 10-Mbps link is present. Link status amber + speed solid green—A half-duplex, 100-Mbps link is present. Link status off + speed blinking green—A full-duplex, 10-Mbps link is present. Link status amber + speed blinking green—A full-duplex, 100-Mbps link is present. |
|
10/100 Ethernet speed 1 |
||
Read both link status and speed for the following: Link status off + speed off—No link is present on this port. Link status off + speed solid green—A half-duplex, 10-Mbps link is present. Link status green + speed solid green—A half-duplex, 100-Mbps link is present. Link status amber + speed solid green—A half-duplex, 1000-Mbps link is present. Link status off + speed blinking green—A full-duplex, 10-Mbps link is present. Link status green + speed blinking green—A full-duplex, 100-Mbps link is present. Link status amber + speed blinking green—A full-duplex, 1000-Mbps link is present. |
||
1.This port used for CIMC configuration only. Cisco Nexus Cloud Services Platform supports network traffic on Gigabit ports only. |