Step 1
| From global configuration mode, enter the
cr10k card oir-compatibility command for
the cable interface line card that you want to OIR.
Example:
Router(config)# cr10k card 8/0 oir-compatibility
This command helps preserve the configuration and performs some
internal synchronization to make sure that the OIR runs successfully.
Note
|
The console log displays a new message appears whenever a line
card type has been replaced. For example, if the MC520U-D in subslot 8/1 is
replaced by an MC520S-D, the following message is displayed:
%UBR10K-6-COMPAT_NEW_CARD: The 5cable-mc520u-d in slot 8/1 has been replaced by a 5cable-mc520s-d
|
This message appears when an OIR operation involves two different
types of MC520 line cards.
Caution
|
The console log message does not appear for cards other than the
MC520S/U/H. It also does not appear if the OIR operation involves identical
MC520 card types. For instance, it will not appear if an MC520U is replaced by
another MC520U. In such cases, you not only might have to reconfigure the
interfaces, we recommend that you reload the router.
|
|
Step 8
| Enter the
show interface cable command and verify
that the card and line protocol is "up".
Example:
Router# show interface cable 8/0/0
Cable8/0/0 is up, line protocol is up
Hardware is BCM3210 ASIC, address is 000a.13e8.1ca8 (bia 000a.13e8.1a60)
Internet address is 10.1.1.3/24
MTU 1500 bytes, BW 27000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation, loopback not set, keepalive not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 4d07h, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 1834000 bits/sec, 2385 packets/sec
5 minute output rate 1982000 bits/sec, 2431 packets/sec
24461542 packets input, 2348214388 bytes, 0 no buffer
Received 1979 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
24854257 packets output, 2536222931 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
|