Session Destinations

A monitoring session consists of one or more source ports and a single destination ports. A destination port must be configured on the start and final devices. On the start device, this is the reflector port. On the final device, it is the analyzer port.

To add a destination port, follow these steps:

Procedure

Step 1

Click Status and Statistics >SPAN & RSPAN> Session Destinations.

Step 2

Click Add.

Step 3

Enter the following fields:

  • Session ID—Select a session ID. This must match the session IDs of the source ports.

  • Destination Type – Select a local interface or remote VLAN as destination.

  • Port—Select a port from the drop-down list.

  • Network Traffic—Select to enable that traffic other than monitored traffic is possible on the port.

Step 4

Click Apply.