The Etherlike page displays statistics per port according to the Etherlike MIB standard definition. The refresh rate of the information can be selected. This page provides more detailed information regarding errors in the physical layer (Layer 1) that might disrupt traffic.
To view Etherlike Statistics and/or set the refresh rate follow these steps:
Procedure
| Step 1 | Click Status and Statistics > Etherlike. |
| Step 2 | To view statistics counters in table view, click View All Interfaces Statistics to see all ports in table view.
-
Select the refresh rate from the Refresh Rate drop-down menu.
-
Select an interface and click Clear Interface Counters to clear the statistics counters for the selected interface.
-
Click Clear All Interface Counters to clear the statistics counters for all interfaces.
-
Select an interface and click View Interface Statistics to see the statistics counters for the selected interface on a single page.
-
Click Refresh to manually refresh the statistics counters for all interfaces.
|
| Step 3 | Enter the parameters.
The fields are displayed for the selected interface.
-
Frame Check Sequence (FCS) Errors - Received frames that failed the CRC (cyclic redundancy checks).
-
Single Collision Frames- Frames that involved in a single collision, but successfully transmitted.
-
Late Collisions - Collisions that have been detected after the first 512 bits of data.
-
Excessive Collisions - Transmissions rejected due to excessive collisions.
-
Oversize Packets - Packets greater than 2000 octets received.
-
Internal MAC Receive Errors - Frames rejected because of receiver errors.
-
Pause Frames Received - Received flow control pause frames.
-
Pause Frames Transmitted - Number of flow control pause frames transmitted from the selected interface.
|
| Step 4 | You can also click Refresh to refresh the stats or click Clear Interface Counters to clear the counters. |