Optical Module Status

The Optical Module Status page displays the operating conditions reported by the SFP (Small Form-factor Pluggable) transceiver.

The following GE SFP (1000Mbps) transceivers are supported:

  • MGBLH1: 1000BASE-LH SFP transceiver, for single-mode fiber, 1310 nm wavelength, supports up to 40 km.

  • MGBLX1: 1000BASE-LX SFP transceiver, for single-mode fiber, 1310 nm wavelength, supports up to 10 km.

  • MGBSX1:1000BASE-SX SFP transceiver, for multimode fiber, 850 nm wavelength, supports up to 550 m.

  • MGBT1: 1000BASE-T SFP transceiver for category 5 copper wire, supports up to 100 m.

  • GLC-SX-MMD - 1000BASE-SX short wavelength; with DOM

  • GLC-LH-SMD - 1000BASE-LX/LH long-wavelength; with DOM

  • GLC-BX-D - 1000BASE-BX10-D downstream bidirectional single fiber; with DOM

  • GLC-BX-U - 1000BASE-BX10-U upstream bidirectional single fiber; with DOM

  • GLC-TE - 1000BASE-T standard

The following XG SFP+ (10,000Mbps) transceivers are supported:

  • Cisco SFP-10G-SR

  • Cisco SFP-10G-LR

  • Cisco SFP-10G-SR-S

  • Cisco SFP-10G-LR-S

The following XG passive cables (Twinax/DAC) are supported:

  • Cisco SFP-H10G-CU1M

To view the results of optical tests, click Administration > Diagnostics > Optical Module Status.

This page displays the following fields:

  • Port—Port number on which the SFP is connected

  • Temperature—Temperature (Celsius) at which the SFP is operating

  • Voltage—SFPs operating voltage

  • Current—SFPs current consumption

  • Output Power—Transmitted optical power

  • Input Power—Received optical power

  • Loss of Signal—Local SFP reports signal loss. Values are True and False