Interface Settings

Use the Interface Settings page to enable IP Source Guard on the interfaces. To enable IP Source Guard on an interface, complete the following steps:

Procedure

Step 1

Click Security > IP Source Guard > Interface Settings.

Step 2

Select the interface type (Port or LAG), click Go.

Step 3

Select an interface, and click Edit.

Step 4

Enter the following information:

  • Interface—Select a port or LAG.

  • IP Source Guard—Check Enable to enable IP Source Guard on the interface, or uncheck to disable this feature on the interface.

  • Verify Source—Select the type of source traffic to be verified. It can be IP or MAC and IP.

  • Maximum Entry—Enter the maximum number of IP source binding rules. The range is 0 to 50, and 0 means no limit.

Step 5

Click Apply. The IP Source Guard Interface settings are defined, and the Running Configuration is updated.