Bandwidth

The Bandwidth page displays bandwidth information for each interface. To view the bandwidth information, complete the following steps:

Procedure

Step 1

Click Quality of Service > General > Bandwidth.

The fields in this page are described in the Edit page below, except for the following fields:

  • Ingress Rate Limit:

    • Status—Displays whether Ingress Rate Limit is enabled.

    • Rate Limit (KBits/sec)—Displays the ingress rate limit for the port.

    • %—Displays the ingress rate limit for the port divided by the total port bandwidth.

  • Egress Shaping Rates:

    • Status—Displays whether Egress Shaping Rates is enabled.

    • CIR (KBits/sec)—Displays the maximum bandwidth for the egress interface.

Step 2

Select an interface, and click Edit.

Step 3

Select the Port interface.

Step 4

Enter the fields for the selected interface:

OptionDescription

Ingress Rate Limit

Select to enable the ingress rate limit, which is defined in the field below. (Not relevant for LAGs).

Ingress Rate Limit (Kbits per sec)

Enter the maximum amount of bandwidth allowed on the interface. (Not relevant for LAGs).

Egress Shaping Rate

Select to enable egress shaping on the interface.

Committed Information Rate (CIR)

Enter the maximum bandwidth for the egress interface.
Step 5

Click Apply. The bandwidth settings are written to the Running Configuration file.