Cisco CallManager Serviceability System Guide, Release 4.1(2)
Path Analysis

Table Of Contents

Path Analysis

Path Analysis Operation

Call Detail Records Logging

Path Analysis Configuration Checklist

Where to Find More Information


Path Analysis


This chapter provides a description and overview of Path Analysis and contains the following topics:

Path Analysis Operation

Call Detail Records Logging

Path Analysis Configuration Checklist

Where to Find More Information

Using Path Analysis with Cisco CallManager requires the installation of the Common Management Foundation 1.1.1 Voice Manager patch on the CiscoWorks2000 server.

Path Analysis Operation

Path Analysis, a diagnostic application, traces connectivity between two specified points on a network. It analyzes both physical and logical paths (Layer 2 and Layer 3) that are taken by packets that flow between those points.

After a call completes, PathTool traces the route of audio packets by specifying the directory number of the calling and called parties. This applies to calls among any of the following endpoints: Cisco IP Phones, analog devices that are connected to a station gateway, or trunk gateways (analog or digital).

For more information, consult CiscoWorks2000 online help.

The information that is presented here assists you in setting up Cisco CallManager. You can display the paths that are traced in the form of maps, trace logs, or tables in CiscoWorks2000 Campus Manager.

Call Detail Records Logging

You can activate voice over IP (VoIP) traces only when Cisco CallManager is installed with call detail record (CDR) logging enabled. The default status specifies disabled.

Path Analysis Configuration Checklist

Table 20-1 provides an overview of the steps for configuring Path Analysis.

Table 20-1 Path Analysis Configuration Checklist 

Configuration Steps
Related Procedures and Topics

Step 1 

Review Cisco AVVID network management documentation for path analysis information.

Cisco IP Telephony Network Design Guide

http://www.cisco.com/univercd/cc/td/doc/product/voice/ip_tele/network/

Step 2 

Install the Common Management Foundation 1.1.1 Voice Manager patch on the CiscoWorks2000 server.

CiscoWorks2000 user documentation:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/index.htm

Step 3 

Enable CDR logging.

Setting Up Call Detail Records Logging, Cisco CallManager Serviceability Administration Guide

Where to Find More Information

Related Topics

"CiscoWorks2000"

"Overview of CiscoWorks2000," Cisco CallManager Serviceability Administration Guide

Additional Cisco Documentation

CiscoWorks2000 user documentation:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/index.htm

Cisco IP Telephony Network Design Guide

http://www.cisco.com/univercd/cc/td/doc/product/voice/ip_tele/network/