本文描述使用的方法为了识别在Cisco Catalyst 6500系列交换机的奇偶校验的影响的模块。
Cisco 建议您了解以下主题:
本文档中的信息根据运行Supervisor引擎720的Cisco Catalyst 6500系列交换机。
本文档中的信息都是基于特定实验室环境中的设备编写的。本文档中使用的所有设备最初均采用原始(默认)配置。如果您使用的是真实网络,请确保您已经了解所有命令的潜在影响。
您也许遇到此登录Catalyst 6500系列交换机:
%LTL-SP-2-LTL_PARITY_CHECK: LTL parity check request for 0x33C9
日志指示在某些(SRAM)的奇偶校验使用的端口ASIC/port索引表静态随机访问存储器Catalyst 6500系列模块。
为了识别遇到奇偶校验的模块,请变换在登录看到的十六进制数十进制。在这种情况下, 0x33C9翻译对十进制13,257。
收集从show diagnostic result module的输出所有detail命令在交换机和搜索13,257的。它列出作为其中一个的LTL索引模块。
例如:
6500#show diagnostic result module all detail
Module 1: CEF720 8 port 10GE with DFC SerialNo : XXXXXXXXXX
Overall Diagnostic Result for Switch 1 Module 1 : PASS
Diagnostic level at card bootup: minimal
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
1) TestOBFL ------------------------> .
<snip>
15) TestLtlFpoeMemoryConsistency ----> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 2889738
Last test testing type ------> Health Monitoring
Last test execution time ----> Mar 15 2013 02:06:57
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Mar 15 2013 02:06:57
Total failure count ---------> 0
Consecutive failure count ---> 0
LTL PARITY
Ltl index -------------------> 13257
Rbh value -------------------> 255
<snip>
通过输出移动为了发现映射对此LTL,是模块日志来自的模块。