Show Command(s) and/or Outputs
show subscribers control-plane-only all
This command displays the following Control Plane specific information for the session. Following is a sample output:
-
Access Type
-
(R) - sgw-pdn-type-ipv4
-
(O) - sgw-pdn-type-ipv6
-
(Q) - sgw-pdn-type-ipv4-ipv6
-
(@) - saegw-gtp-ipv4
-
(#) - saegw-gtp-ipv6
-
($) - saegw-gtp-ipv4-ipv6
-
(W) - pgw-gtp-ipv4
-
(Y) - pgw-gtp-ipv6
-
(Z) - pgw-gtp-ipv4-ipv6
-
(.) – Unknown
-
-
Access Tech
-
(U) - UTRAN
-
(G) - GERAN
-
(E) - eUTRAN
-
(.) - Unknown
-
-
Call State
-
(C) - Connected
-
(c) - Connecting
-
(S) - Suspended
-
(d) - Disconnecting
-
(I) - Idle
-
(u) - Unknown
-
-
Bearer Type
-
(D) - Default
-
(E) - Dedicated
-
(I) - Indirect Forwarding
-
-
PLMN
-
(H) - Home
-
(V) – Visiting
-
(R) - Roaming
-
(u) - Unknown
-
-
Emergency Bearer Type
-
(A) - Authentic IMSI
-
(U) - Un-Authentic IMSI
-
(O) - Only IMEI
-
(N) - Non-Emergency
-
-
Addr
-
(L) - Local pool
-
(S) - Static (Subscriber Supplied)
-
Type: (u) - Unknown
-
-
CALLID
-
LOCAL SEID
-
IMSI/IMEI
-
EBI
-
V
-
IP
-
PDN-INSTANCE
-
User Plane Address
-
TIME-IDLE
Note |
|
show session disconnect-reasons
The following disconnect reasons has been added in support of Control Plane in CUPS:
-
user-plane-info-not-available(651)
This disconnect reason is seen in following conditions:
-
user-plane-profile is not associated with APN Profile for Pure-S call.
-
user-plane-profile is not associated with IP Pool for Pure-P call.
-
Associated user-plane-profile is not configured.
-
Associated user-plane-profile is not configured with endpoint address
-
-
user-plane-info-mismatch(652)
-
For multiple PDN call with same APN, and for IPv4 and IPv6 call, it is mandatory that same User Plane profile is selected. Any variation will result in call creation failure with this disconnect reason.
-
-
sx-max-trans-threshold-reached(676): Calls are dropped with this disconnect reason if the outstanding Sx transaction exceeds 12.
show subscribers saegw-only full all
Executing this command displays the following fields:
-
User Plane Address
-
Local SEID
-
Remote SEID
-
show subscribers saegw-only seid seid_value
Executing this command displays the following fields:
-
vvvvvv
-
CALL ID
-
IMSI/IMEI
-
EBI
-
v
-
IP
-
APN
-
TIME-IDLE