Adding and Deleting Systems
This chapter describes how to add and delete a mobility services engine from Cisco WCS.
This chapter contains the following sections:
•"Adding a Mobility Services Engine to Cisco WCS" section
•"Deleting a Mobility Services Engine from the Cisco WCS" section
Adding a Mobility Services Engine to Cisco WCS
To add a Cisco 3300 Series Mobility Services Engine to Cisco WCS, log into WCS and follow these steps:
Step 1 Verify that you can ping the mobility service engine that you want to add from Cisco WCS.
Step 2 Click Mobility > Mobility Services to display the Mobility Services window.
Step 3 From the Select a command drop-down menu, select Add Mobility Services Engine and click GO.
Step 4 In the Device Name field, enter a name for the mobility services engine.
Step 5 In the IP Address field, enter the mobility services engine's IP address.
Step 6 (Optional) In the Contact Name field, enter the name of the mobility services engine administrator.
Step 7 In the User Name and Password fields, enter the username and password for the mobility services engine.
The default username and password are both admin.
Note If you changed the username and password during the automatic installation script, enter those values here. If you did not change the default passwords, Cisco strongly recommends that you rerun the automatic installation script and change the username and password.
Step 8 Click Next. The Select Mobility Service window appears (Figure 2-1).
Figure 2-1 Mobility Services Engine > Select Mobility Service
Step 9 To enable one service on the mobility services engine, click the circle next to that service.
Note A mobility services engine can only be configured to support a single service at a time.
Step 10 Click Save.
Note After adding a new mobility services engine, you can synchronize network designs (campus, building, and outdoor maps) and event groups on the local mobility services engine with Cisco WCS. You can also choose to synchronize the mobility services engine with a specific controller. You can do this synchronization immediately after adding a new mobility services engine or at a later time. To synchronize the local and Cisco WCS databases, continue to the "Synchronizing Cisco WCS and a Mobility Services Engine" section on page 3-2.
Deleting a Mobility Services Engine from the Cisco WCS
To delete a mobility services engine from the Cisco WCS database, follow these steps:
Step 1 Click Mobility > Mobility Services to display the Mobility Services window.
Step 2 Select the mobility services engine(s) to be deleted by checking the corresponding check box(es).
Step 3 From the Select a command drop-down menu, select Delete Service(s) and click GO.
Step 4 Click OK to confirm that you want to delete the selected mobility services engine from the WCS database.
Step 5 Click Cancel to stop deletion.