Timeout for Disabled Clients
You can configure a timeout for disabled clients. Clients who fail to authenticate three times when attempting to associate are automatically disabled from further association attempts. After the timeout period expires, the client is allowed to retry authentication until it associates or fails authentication and is excluded again. Use these commands to configure a timeout for disabled clients.
Configuring Timeout for Disabled Clients (CLI)
-
Configure the timeout for disabled clients by entering the config wlan exclusionlist wlan_id timeout command. The valid timeout range is 1 to 2147483647 seconds. A value of 0 permanently disables the client.
-
Verify the current timeout by entering the show wlan command.