Remote Server List Configuration Mode Commands

Mode

The Remote Server List Configuration Mode manages the list of server addresses to which a context has access.

Exec > Global Configuration > Remote Server List Configuration

configure > context context_name > remote-server-list name list_name 

[context_name]host_name(config-remote-server-list)#

Important

Available commands or keywords/variables vary based on platform type, product version, and installed license(s).

address

Configures or removes an IP address to a remote server.

Product

All

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Remote Server List Configuration

configure > context context_name > remote-server-list name list_name 

[context_name]host_name(config-remote-server-list)#

Syntax

address  remote-ip-address netmask  ip_netmask 
no address  remote-ip-address netmask  ip_netmask

no

Removes the specified IP address from the Remote Server List.

remote-ip-address netmask ip_netmask

Specifies the IP address and netmask of the remote server in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.

Usage Guidelines

Use this command to create and maintain a list of remote servers accessible by this context.

Examples

address 193.154.78.9 netmask 255.255.255.0

do show

Executes all show commands while in Configuration mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

do show

Usage Guidelines

Use this command to run all Exec mode show commands while in Configuration mode. It is not necessary to exit the Config mode to run a show command.

The pipe character | is only available if the command is valid in the Exec mode.


Caution

There are some Exec mode show commands which are too resource intensive to run from Config mode. These include: do show support collection , do show support details , do show support record and do show support summary . If there is a restriction on a specific show command, the following error message is displayed: 

Failure: Cannot execute 'do	show support' command from Config mode.

end

Exits the current configuration mode and returns to the Exec mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

end

Usage Guidelines

Use this command to return to the Exec mode.

exit

Exits the current mode and returns to the parent configuration mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

exit

Usage Guidelines

Use this command to return to the parent configuration mode.