end
Exits the current configuration mode and returns to the Exec mode.
Product
All
Privilege
Security Administrator, Administrator
Syntax
end
Usage Guidelines
Use this command to return to the Exec mode.
The ACS Group-of-Objects Configuration Mode is used to configure groups of Active Charging Service (ACS) objects.
![]() Important |
This configuration mode is available only in 10.2 and later releases. |
Exec > ACS Configuration > ACS Group-of-Objects Configuration
active-charging service service_name > group-of-objects object_name [ type string ]
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-group-of-objects)#
![]() Important |
The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s). |
Exits the current configuration mode and returns to the Exec mode.
All
Security Administrator, Administrator
end
Use this command to return to the Exec mode.
Exits the current mode and returns to the parent configuration mode.
All
Security Administrator, Administrator
exit
Use this command to return to the parent configuration mode.
This command allows you to add or remove objects from the current group-of-objects.
![]() Important |
A maximum of 128 objects can be added to a group-of-objects. |
ACS
Security Administrator, Administrator
Exec > ACS Configuration > ACS Group-of-Objects Configuration
active-charging service service_name > group-of-objects object_name [ type string ]
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-group-of-objects)#
[ no ] member-object object
If previously added, removes the specified member object from the current group-of-objects.
Specifies the member object to add to or remove from the current group-of-objects.
object must be an alpha and/or numeric string of 1 through 63 characters.
Use this command to add or remove member objects from a group-of-objects.
member-object test