|| In the
vSphere Client login dialog box, enter your login credentials.
Navigation pane, choose the
UCS Director deployment.
OVF Template window appears.
|| In the
Source pane, do one of the following to choose your
OVF source location:
- Browse to the location,
choose the file, and click
- Deploy from a URL on your
local area network. Replace
FQDN (Fully Qualified Domain Name) with the IP address
or domain name, and click
Template Details pane, verify the details and click
License Agreement pane, read the license agreement, and
Accept. Click Next.
Location pane, do the following:
- Optional: In the
Name field, edit the VM name.
- Choose the
UCS Director is being deployed, and click
Center was chosen in a previous step, option b is not available.
Host/Cluster pane, choose the required host, cluster,
or resource pool, and click
Datastore pane, choose the location to store
UCS Director VM files, and click
Format pane, choose one of the following radio buttons and click
- Thin Provisioned
format—To allocate storage on demand as data is written to disk.
- Thick Provisioned (Lazy
Zeroed) format —To allocate storage immediately in thick format.
- Thick Provisioned (Eager
Zeroed) format —To allocate storage in thick format. It might take
longer to create disks using this option.
Mapping pane, choose your network and click
Address Allocation pane, click
The DHCP check
box is checked by default.
Complete pane, verify the options selected, and click
||Make sure you
have sufficient vCPU and memory to power on the VM.
||Power on the VM.
appliance starts up, do the following when you are prompted to configure a
you can configure network properties from the shelladmin. You can either
configure using the shelladmin or from
UCS Director VMs console window in the vCenter.
- If you want to use DHCP,
n to ensure that IP addresses are assigned
- If you want to use static IP
y and then you will be prompted to select IPV4 or
V4 to configure IPV4 and then enter the following
||When you are
prompted to continue with the configuration, enter
Wait for the
appliance to boot up before you continue.
appliance has booted up, transfer the
UCS Director IP address (from the IP address that
is shown) into a supported web browser to access the
Login page, enter
admin as the username and
admin for the login password.
Change your admin password after this initial login.