When a fault or condition is cleared in Cisco UCS domain , the corresponding alert in operations manager is set to cleared state. There is no manual activity required to close an
alert in the Operations Manager console.
By, default, for every 90 seconds interval all alerts are cleared. However, you can modify the interval period.
Rule Name: Cisco UCS Update and Close Alert Rule
Target: All Management Servers Resource Pool
Enabled: This parameter can be used to enable or disable the rule ( default value: true)
EventQueryIntervalInSeconds : This parameter is used to set the desired time interval for which the events should be queries
(default value : 120 seconds )
If this parameter value is set to 0, then the rule processes all the older events every time it runs. Hence, to avoid timeout and overlapping between consecutive
runs of this rule, you should also set the parameters Interval Seconds and Timeout Seconds accordingly to higher values.
Interval Seconds: This parameter is used to set the frequency to run the rule (default value : 90 seconds)
Logging: set the logging (default value : false)
Timeout Seconds: Set the time out interval for the rule (default value : 60 seconds)