Chassis LEDs
This table provides information about chassis LEDs for Cisco Nexus 3000 Series switches.
Component |
LED |
Status |
Description |
|
---|---|---|---|---|
Chassis (front and back) |
Beacon (BCN) |
Flashing blue |
The operator has activated this LED to identify this switch in the chassis. |
|
Identification (ID) |
On (blue) |
Identifies the chassis receiving the beacon signal. |
||
Management (MGMT) |
Left side Off Solid on (green) |
This port has no physical link. |
||
This port has a physical link. |
||||
Right side Off Blinking (green) |
This port has no activity. |
|||
This port has activity. |
||||
Port |
Customer defined states |
Green and amber LED used to indicate customer-defined status for each port. |
||
Off |
This port is not in use. This port is unusable during breakout. |
|||
Status (STS) |
Solid on (green) |
All diagnostics pass. The module is operational. |
||
Off |
The module is not receiving power. |
|||
On (amber) |
The module is booting or running diagnostics. The switch is overheating. The temperature threshold has been exceeded by a small value during environmental monitoring. |
|||
Blinking (amber) |
The switch has overheated. The temperature threshold has been exceeded by a large value during environmental monitoring. If the module fails during initial reset, the LED continues to blink and the module does not come online. The module has a runtime failure and is brought offline. |