New and Changed Information
The latest version of this document is available at the following Cisco website:
To check for additional information about this Cisco NX-OS Release, see the Cisco Nexus 3000 Series Switch NX-OS Release Notes, available at the following Cisco website:
This table summarizes the new and changed features for the Cisco Nexus 3000 Series NX-OS Multicast Routing Configuration Guide, and tells you where they are documented.
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
Multicast VRF-lite route leaking |
Introduced this feature. |
7.0(3)I7(1) |
|
|
PIM |
Added the ability to configure the Bidir RPs. |
7.0(3)I6(1) |
|
|
PIM |
Added support to PIM or PIM6 sparse mode |
7.0(3)I6(1) |
|
|
IGMP Snooping |
Added the ip igmp snooping report-flood and ip igmp snooping proxy-leave use-group-address commands. |
7.0(3)I4(2) |
|
|
PIM |
Added PIM SSM support over vPCs. |
7.0(3)I4(1) |
|
|
Configuring Multicast Table Size |
Added a section on configuring multicast and unicast entries in the multicast table. |
7.0(3)I2(1) |
|
|
Guideline for configuring show ip pim rp command |
The loopback interface that is used as a RP in multicast must have the ip pim sparse-mode configuration. |
7.0(3)I2(1) |
|
|
Updated output of the CLI command clear ip igmp snooping |
The output of the CLI command clear ip igmp snooping displays extra options, for example, access-group, groups, proxy, and report-policy |
7.0(3)I2(1) |
|
|
Guideline for the loopback interface that is used as a RP in multicast to have the ip pim sparse-mode configuration |
Added the guideline for the loopback interface that is used as a RP in multicast to have the ip pim sparse-mode configuration. |
7.0(3)I2(1) |
|
|
Invalid table-id with CLI command show ip fib mroute in the VRF configured interface. |
When you configure an interface in the VRF, configure the PIM, send the IGMP joins and verify the CLI command show ip fib mroute , an error message is displayed as follows: ERROR: Invalid Table-id. When a group is learned in the default table, the default table is created and the error message is not displayed anymore. |
7.0(3)I2(1) |
Feedback