The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco Nexus 1000V commands that begin with the letter Q.
To enable the recording of QoS statistics, use the qos statistics command. To disable the recording of QoS statistics, use the no form of this command.
|
|
This example shows how to enable the recording of QoS statistics:
n1000v#
configure terminal
n1000v(
config)#
qos statistics
|
|
---|---|
Displays the policy map configuration for all policy maps or for a specified policy map. |
To configure the queue size in a number of packets, use the queue-limit command. To set the default, use the no form of this command.
queue-limit { q-size [ packets]}
no queue-limit { q-size [ packets]}
policy-map type queuing class configuration (config-pmap-c-que)
|
|
This example shows how to configure the queue limit to 5000 packets:
n1000v(
config-pmap-c-que)#
queue-limit 5000 packets
|
|
---|---|
Configures the minimum guaranteed bandwidth for a specific traffic class in a QoS policy map. |
|