1.
Power on the switch. Switches in the Cisco MDS 9000 Family boot
automatically.
2.
Enter the new password for the administrator.
3.
Enter
yes to enter the setup mode.
4.
Enter
yes (yes is the default) to enable secure
password standard
5.
Enter
no (no is the default) if you do not wish to
create additional accounts.
6.
Configure the read-only or read-write SNMP community string.
7.
Enter a name for the switch.
8.
Enter
no (yes is the default) at the configuration
prompt to configure out-of-band management.
9.
Enter
yes (yes is the default) to configure the
default gateway.
10.
Enter
yes (no is the default)
to configure advanced IP options such as in-band management, static routes,
default network, DNS, and domain name.
11.
Enter
no (no is the default)
to disable the Telnet service.
12.
Enter
yes (yes is the
default) to enable the SSH service.
13.
Enter the SSH key type.
14.
Enter the number of key bits within the specified range.
15.
Enter
no (no is the default)
to configure the NTP server.
16.
Enter
shut (shut is the
default) to configure the default switch port interface to the shut (disabled)
state.
17.
Enter
auto (off is the
default) to configure the switch port trunk mode.
18.
Enter
yes (yes is the
default) to configure the switchport mode F.
19.
Enter
off (off is the
default) to configure the PortChannel auto-create state.
20.
Enter
deny (deny is the
default) to deny a default zone policy configuration.
21.
Enter
no (no is the default)
to disable a full zone set distribution.
22.
Enter
enhanced (basic is the
default) to configure default-zone mode as enhanced.
23.
Enter
no (no is the default)
if you are satisfied with the configuration.
24.
Enter
yes (yes is default) to
use and save this configuration.