Cisco APIC Layer 4 to Layer 7 Services Deployment Guide, Release 5.0(x)

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: May 14, 2020

New and Changed Information

The following table provides an overview of the significant changes to this guide for this release. The table does not provide an exhaustive list of all changes made to the guide or of the new features up to this release.

Table 1. New Features and Changed Behavior for Cisco APIC Release 5.0(1).
Feature	Description	Where Documented
Layer 1/Layer 2 Policy-Based Redirect devices	Active-active deployment/ECMP paths are supported for Layer 1/Layer 2 PBR devices.	See Active/Active Layer 1/Layer 2 Symmetric PBR Design Overview
Configuring Policy Based Redirect with L3Out	L3Outs are supported on all provider side of the service nodes.	See Policy-Based Redirect with an L3Out

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)