A fabric administrator creates domain policies that configure ports, protocols, VLAN pools, and encapsulation. These policies can be used exclusively by a single tenant, or shared. Once a fabric administrator configures domains in the ACI fabric, tenant administrators can associate tenant endpoint groups (EPGs) to domains.
The following networking domain profiles can be configured:
VMM domain profiles (
vmmDomP) are required for virtual machine hypervisor integration.
Physical domain profiles (
physDomP) are typically used for bare metal server attachment and management access.
Bridged outside network domain profiles (
l2extDomP) are typically used to connect a bridged external network trunk switch to a leaf switch in the ACI fabric.
Routed outside network domain profiles (
l3extDomP) are used to connect a router to a leaf switch in the ACI fabric.
Fibre Channel domain profiles (
fcDomP) are used to connect Fibre Channel VLANs and VSANs.
A domain is configured to be associated with a VLAN pool. EPGs are then configured to use the VLANs associated with a domain.
EPG port and VLAN configurations must match those specified in the domain infrastructure configuration with which the EPG associates. If not, the APIC will raise a fault. When such a fault occurs, verify that the domain infrastructure configuration matches the EPG port and VLAN configurations.
For more information about Layer 3 Networking, see Cisco APIC Layer 3 Networking Configuration Guide.
For information about configuring VMM Domains, see Cisco ACI Virtual Machine Networking in Cisco ACI Virtualization Guide.