Configure Intra-EPG Isolation for Cisco ACI Virtual Edge Using the GUI
Follow this procedure to create an EPG in which the endpoints of the EPG are isolated from each other.
The port that the EPG uses must belong to one of the VM Managers (VMMs).
Note |
This procedure assumes that you want to isolate endpoints within an EPG when you create the EPG. If you want to isolate endpoints within an existing EPG, select the EPG in Cisco APIC, and in the Properties pane, in the Intra EPG Isolation area, choose Enforced, and then click SUBMIT. |
Before you begin
Make sure that VXLAN-related configuration is present on the Cisco ACI Virtual Edge VMM domain, particularly a Cisco ACI Virtual Edge fabric-wide multicast address and pool of multicast addresses (one per EPG).
Procedure
Step 1 |
Log in to Cisco APIC. |
Step 2 |
Choose Tenants, expand the folder for the tenant, and then expand the Application Profiles folder. |
Step 3 |
Right-click an application profile, and choose Create Application EPG. |
Step 4 |
In the Create Application EPG dialog box, complete the following steps: |
What to do next
You can select statistics and view them to help diagnose problems involving the endpoint. See the sections Choose Statistics for Isolated Endpoints on Cisco ACI Virtual Edge Under the Tenants Tab and View Statistics for Isolated Endpoints on Cisco ACI Virtual Edge Under the Tenants Tab in this guide.