Busies |
Number of times that the operation cannot be started because the previously scheduled run was not finished. |
Entry Number |
Entry number. |
Hop in Path Index |
Hop in path index. |
Errors |
Number of internal errors. |
Jitter Values |
Jitter statistics appear on the specified lines. Jitter is defined as interpacket delay variance. |
NumOfJitterSamples |
Number of jitter samples that are collected. The number of samples are used to calculate the jitter statistics. |
Number of Failed Operations due to a Disconnect |
Number of failed operations due to a disconnect. |
Number of Failed Operations due to a Timeout |
Number of failed operations due to a timeout. |
Number of Failed Operations due to a Busy |
Number of failed operations due to a busy error. |
Number of Failed Operations due to a No Connection |
Error that refers to the case in which the control connection cannot be established. |
Number of Failed Operations due to an Internal Error |
Number of failed operations due to an internal error. |
Number of Failed Operations due to a Sequence Error |
Number of failed operations due to a sequence error. |
Number of Failed Operations due to a Verify Error |
Number of failed operations due to a verify error. |
MaxOfNegativesSD |
Maximum negative jitter values from the source to the destination. The absolute value is given. |
MaxOfPositivesSD |
Maximum jitter values from the source to the destination in milliseconds. |
MaxOfPositivesDS |
Maximum jitter values from the destination to the source in milliseconds. |
MaxOfNegativesDS |
Maximum negative jitter values from destination-to-source. The absolute value is given. |
MinOfPositivesDS |
Minimum jitter values from the destination to the source in milliseconds. |
MinOfNegativesSD |
Minimum negative jitter values from the source to the destination. The absolute value is given. |
MinOfPositivesSD |
Minimum jitter values from the source to the destination in milliseconds. |
MinOfNegativesDS |
Minimum negative jitter values from the destination to the source. The absolute value is given. |
NumOfOW |
Number of successful one-way time measurements. |
NumOfNegativesDS |
Number of jitter values from the destination to the source that are negative; for example, network latency decreases for two consecutive test packets. |
NumOfNegativesSD |
Number of jitter values from the source to the destination that are negative; for example, network latency decreases for two consecutive test packets. |
NumOfPositivesDS |
Number of jitter values from the destination to the source that are positive; for example, network latency increases for two consecutive test packets. |
NumOfPositivesSD |
Number of jitter values from the source to the destination that are positive; for example, network latency increases for two consecutive test packets. |
NumOfRTT |
Number of successful round trips. |
One Way Values |
One-way measurement statistics appear on the specified lines. One Way (OW) values are the amount of time that it took the packet to travel from the source router to the target router or from the target router to the source router. |
OWMaxDS |
Maximum time from the destination to the source. |
OWMaxSD |
Maximum time from the source to the destination. |
OWMinDS |
Minimum time from the destination to the source. |
OWMinSD |
Minimum time from the source to the destination. |
OWSumDS |
Sum of one-way delay values from the destination to the source. |
OWSumSD |
Sum of one-way delay values from the source to the destination. |
OWSum2DS |
Sum of squares of one-way delay values from the destination to the source. |
OWSum2SD |
Sum of squares of one-way delay values from the source to the destination. |
PacketLateArrival |
Number of packets that arrived after the timeout. |
PacketLossDS |
Number of packets lost from the destination to the source (DS). |
PacketLossSD |
Number of packets lost from the source to the destination (SD). |
PacketMIA |
Number of packets lost in which the SD direction or DS direction cannot be determined. |
PacketOutOfSequence |
Number of packets that are returned out of order. |
Path Index |
Path index. |
Port Number |
Target port number. |
RTTSum |
Sum of all successful round-trip values in milliseconds. |
RTTSum2 |
Sum of squares of the round-trip values in milliseconds. |
RTT Values |
Round-trip time statistics appear on the specified lines. |
Start Time |
Start time, in milliseconds. |
Start Time Index |
Statistics that are aggregated for over 1-hour intervals. The value indicates the start time for the 1-hour interval that is displayed. |
SumOfPositivesDS |
Sum of the positive jitter values from the destination to the source. |
SumOfPositivesSD |
Sum of the positive jitter values from the source to the destination. |
SumOfNegativesDS |
Sum of the negative jitter values from the destination to the source. |
SumOfNegativesSD |
Sum of the negative jitter values from the source to the destination. |
Sum2PositivesDS |
Sum of squares of the positive jitter values from the destination to the source. |
Sum2PositivesSD |
Sum of squares of the positive jitter values from the source to the destination. |
Sum2NegativesDS |
Sum of squares of the negative jitter values from the destination to the source. |
Sum2NegativesSD |
Sum of squares of the negative jitter values from the source to the destination. |
Target Address |
Target IP address. |