The ip cef accounting command is not supported on the router.
Crash may be observed on the router when:
EoMPLS, CEM, ATM and IMA Pseudowire Redundancy (PW-redundancy) configurations exist while switchover and fail-back of the pseudowires are being triggered, and the show platform hardware pp active pw eompls command is executed.
Configuration sync does not happen on the Standby RSP when the active RSP has Cisco Software Licensing configured, and the standby RSP has Smart Licensing configured on the router. If the active RSP has Smart Licensing configured, the state of the standby RSP is undetermined. The state could be pending or authorized as the sync between the RSP modules is not performed.
Evaluation mode feature licenses may not be available to use after disabling, and enabling the smart licensing on the ASR 903 RSP2 module. A reload of the router is required.
Ingress counters are not incremented for packets of the below format on the RSP3 module for the 10 Gigabit Ethernet interfaces, 100 Gigabit Ethernet interfaces, and 40 Gigabit Ethernet interfaces:
MAC header---->Vlan header---->Length/Type
When these packets are received on the RSP3 module, the packets are not dropped, but the counters are not incremented.
ISSU is not supported between a Cisco IOS XE 3S Release and the Cisco IOS XE Everest 16.5.1.
IPSec is not supported in Cisco IOS XE Everest 16.5.1.