RST Commands
This chapter provides RST (restore) commands for the Cisco ONS 15454 SDH.
20.1 RST-<MOD2>
Restore (10GFC, 10GIGE, 1GFC, 1GFICON, 2GFC, 2GFICON, CLNT, D1VIDEO, DS3I, DV6000, E1, E3, E4, ESCON, ETRCLO, FSTE, G1000, GFPOS, GIGE, HDTV, ISC1, STM4, STM64, STM1, STM16, OCH, OMS, OTS, POS, STM1E, VC3, VC44C, VC38C, VC464C, VC48C, STS36C, VC4, VC416C, VC42C, VC43C, VC11, VC12)
Usage Guidelines
This command provisions a facility in service.
See Table 27-1 for supported modifiers by platform.
Category
Ports
Security
Maintenance
Input Format
RST-<MOD2>:[<TID>]:<AID>:<CTAG>::::[<PST>[,<SST>]];
Input Example
RST-E1:CISCO:FAC-1-1:1::::UNLOCKED,AUTOMATICINSERVICE;
Input Parameters
Table 20-1 RST-<MOD2> Input Parameters
|
|
AID |
Access identifier from the "ALL" section |
PST |
Primary state Parameter type is PST—indicates the current overall service condition of an entity |
• Unlocked |
In service |
• Locked |
Out of service |
SST |
Secondary state Parameter type is SST—provides additional information pertaining to PST and PSTQ |
• AutomaticInService |
Automatic in service |
• Disabled |
Disabled |
• Loopback |
Loopback |
• MismatchofEquipmentAlarm |
Mismatch of equipment and attributes |
• Maintenance |
Maintenance mode |
• OutOfGroup |
Out of group |
• SoftwareDownload |
Software downloading |
• Unassigned |
Unassigned |
• NotInstalled |
Unequipped |
20.2 RST-EQPT
Restore Equipment
Usage Guidelines
This command provisions equipment into the In Service state from the Maintenance state.
Note
Only applicable to equipment that is in transition from the Maintenance state to the In-Service state.
Category
Equipment
Security
Maintenance
Input Format
RST-EQPT:[<TID>]:<AID>:<CTAG>[::];
Input Example
RST-EQPT:CISCO:SLOT-1:1;
Input Parameters
Table 20-2 RST-EQPT Input Parameters
|
|
AID |
Access identifier from the "EQPT" section |