Testing and Debugging Your Report
To test your report:
Step 1 Save your report and its associated .properties file in the /opt/CSCOppm-gw/etc/pollers/user directory.
Step 2 In the Prime Performance Manager GUI, select Reports and then click the Reports Status tab.
Step 3 Scroll down the list of reports and locate your report.
Step 4 Check the check box next to your report and then click the Save icon.
The report should now be active.
Step 5 In the reports tree, click your report to start it.
Step 6 Note any error messages that appear.
Step 7 If you have set up cross-launch of Cisco Prime Performance Management reports:
a. Log into Cisco ANA NetworkVision.
b. Bring up a network map.
c. Locate the device or network location where your cross-launch is set up.
d. Right click on the cross-launch point.
e. Verify that the NetworkVision Device Shortcut has a Performance select; for example, Performance > Device Reports.
f. Click on Device Reports and verify that a Cisco Prime Performance Manager report comes up.
g. Verify that any reports you set up to cross-launch from ANA are available and work correctly.
Common Issues and Error Messages
This section lists common issues error messages that can occur when running reports and provides information on how to resolve the problems.
To see error messages:
Step 1 In the navigation tree, choose Administrative.
Step 2 Click the General tab.
Step 3 To see error messages, under the General heading, choose Error Messages.
Step 4 To see a console log, under System Logs, choose Console Log.
Database Tables Become Unstable
If your report modifies the same tables used by other reports, the database might become unstable.
Also, when there is a change to the existing database like adding a column or renaming a column or deleting a column, table and view drops are required. Make sure these drop views are done in both gateway and unit to avoid inconsistency.
For information on performing a table drop or view drop, see Dropping Tables and Views, page 2-19.
Incorrect MIB Variable
If your report uses an incorrect MIB variable, an error message will appear.
Check the MIB and check the XML code in your report to make sure that the variable is referenced correctly.