To enable virtual
interface bundling, and to reconfigure interface information on the Cisco CMTS
as required, you first configure the virtual interface bundle, then add
additional bundle members for the specified virtual bundle. Perform these steps
on each interface, as needed for all virtual interface bundles.
To remove a
virtual bundle from the interface, use the
no
interface
bundle command in interface configuration mode,
where
n
specifies the bundle identifier:
no
interface
bundle n
If you remove a
member from a bundle, the bundle remains on the interface (even if empty) until
the bundle itself is specifically removed.
For more information on configuring IPv6 parameters for bundle
interface, see
IPv6 on
Cable feature guide.