The Dynamic Hosting Configuration Protocol (DHCP) is used to dynamically assign IP addresses to clients on the network. However, if a client is on a subnet that does not contain a DHCP server, the client cannot communicate with it to receive an IP address. If there is a DHCP relay in the subnet, the relay forwards the IP address request to a DHCP server, which then returns the IP address of the client to the DHCP relay, who then transmits it to the client.
The purpose of this document is to explain how to configure the SFE/SGE Stackable Managed Switches as DHCP relays.
• SFE/SGE Stackable Managed Switches
• v3.0.2.0
Step 1. Log in to the web configuration utility and choose System > System Management > IP Addressing > DHCP Relay > DHCP Server. The DHCP Server page opens:
Step 2. To enable this device as a DHCP relay, choose Enable from the DHCP Relay drop-down list.
Timesaver: If you choose Enable, skip to Step 4.
Step 3. (Optional) To enable Option 82, choose Enable from the Option 82 drop-down list. Option 82 is used to provide information regarding the location of DHCP clients on the network.
Note: This can only be enabled if DHCP snooping has been enabled. See Dynamic Host Configuration Protocol (DHCP) Snooping Properties on SFE/SGE Managed Switches to enable DHCP snooping.
Step 4. Click Apply to save your settings.
Caution: This only saves your configuration to the running configuration file. This means any changes made will be lost if the device is rebooted. If you wish to save these changes even after a system reboot, you need to copy the running configuration file to the startup configuration file. See Copy Configuration File on SFE/SGE Series Managed Switches for more information on how to do this.
Step 1. Click the Add button to add a DHCP server. The Add DHCP Server window appears:
Note: The Supported IP Format field displays the version of Internet Protocol that is supported.
Step 2. Enter the IP address of the DHCP server in the DHCP Server IP Address field.
Step 3. Click Apply. The IP address is shown on the DHCP Server table:
Caution: This only saves your configuration to the running configuration file. This means any changes made will be lost if the device is rebooted. If you wish to save these changes even after a system reboot, you need to copy the running configuration file to the startup configuration file. See Copy Configuration File on SFE/SGE Series Managed Switches for more information on how to do this.
Step 1. Check the check box that corresponds with the DHCP server you wish to delete.
Step 2. Click Delete.
Caution: This only saves your configuration to the running configuration file. This means any changes made will be lost if the device is rebooted. If you wish to save these changes even after a system reboot, you need to copy the running configuration file to the startup configuration file. See Copy Configuration File on SFE/SGE Series Managed Switches for more information on how to do this.