This document explains how to define a range of IP/Network addresses to allow or deny access to the device.
• RV 220W
• RV120W
Step 1. Use the wireless security firewall utility to choose Administration > Management Interface > Users .
.
Step 2. Select a user and click Policies By IP.
.
Step 3. Under the User Policy By source IP Address page, check the box adjacent to the Deny Log in from Defined Addresses to deny log in from the specified IP Address.
Step 4. Check the box adjacent to the Allow Log in from Defined Addresses to allow log in from the specified IP Address.
Step 5. Click Save to apply the changes.
Step 6. Click Add under the Defined Addresses. The Defined Addresses pages opens.
.
Step 7. From the drop down list adjacent to the Source Address Type field select IP Address if it is a host or select Network Address if it is a range of hosts.
Step 8. Enter the IP or Network Address in the Network Address/ IP Address field, that is to be added to the defined addresses list.
Step 9. If it is a Network Address, Enter an appropriate mask length between 0-32 in the Mask Length field.
Step 10. Click Save to apply the changes.
Revision | Publish Date | Comments |
---|---|---|
1.0 |
12-Dec-2018 |
Initial Release |