The RV120W and RV220W have four LAN ports and a WAN port. The Port Management page lets you enable or disable ports, set ports to half/full duplex mode, and set the speed at which they operate.
The objective of this document is to explain the Port Management page on the RV120W and RV220W.
• RV120W
• RV220W
Step 1. Log in to web configuration utility and choose Networking > Port Management.The Port Management page opens:
Step 2. Check or uncheck the Enable check box to enable or disable a port.
Note: The LAN 1 port cannot be disabled.
Step 3. Check the Auto Negotiation check box to have that port automatically detect the Duplex and Speed to operate at.
Step 4. If Auto Negotiation is not checked, choose the Duplex from the Duplex drop-down list. The available options are defined as follows:
• Half-Duplex — Port cannot send and receive at the same time.
• Full-Duplex — Port can send and receive data at the same time.
Step 5. If Auto Negotiation is not checked, choose the Speed from the Speed drop-down list to select the maximum transmission rate the port can operate at.
Step 6. Click Save at the bottom of the configuration utility to save these settings. The settings will be in effect after saving.
Revision | Publish Date | Comments |
---|---|---|
1.0 |
10-Dec-2018 |
Initial Release |