This document describes the steps to remove a single URL entry from the SCE URL database. The Cisco Service Control Engine (SCE) platform-managed URL database resides on the Cisco SCE platform. The URL database, sce-url-database, is managed with the use of CLI commands rather than the Cisco Service Control Application for Broadband (Cisco SCA BB) Console. In addition to the advantage of having a separate URL database that is configurable directly by CLI commands, this database can be used to hide a list of URLs to prevent them from being accessed by the Console or the CLI.
Cisco recommends that you have knowledge of Cisco Service Control Solutions and the URL blacklisting functionality.
The information in this document is based on the test carried out on SCE 8000 with SCOS version 4.1.0, however this document is not restricted to any specific software version.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Steps to Remove a Specific URL from the SCE URL Database
Step 1. Find out the key of the specific URL entry in the Database with the use of the CLI.