This document describes how to configure the Cisco TelePresence Server so that single-screen endpoints do not display in full-screen mode.
Cisco recommends that you have knowledge of the Cisco TelePresence Server.
The information in this document is based on the Cisco TelePresence Server.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Use the information that is described in this section in order to configure the Cisco TelePresence Server so that single-screen endpoints do not display in full-screen mode.
Complete these steps in order to adjust the way that single-screen endpoints are displayed:
Complete these steps in order to override the global setting for an individual endpoint:
There is currently no verification procedure available for this configuration.
There is currently no specific troubleshooting information available for this configuration.