How do I adjust for daylight saving time changes on my Codian products?

Available Languages

Updated:December 30, 2010
Document ID:112323

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This article relates to the Cisco TelePresence MCU 4203, Cisco TelePresence MCU MSE 8420, Cisco TelePresence IP VCR 2210, Cisco TelePresence VCR MSE 8220, Cisco TelePresence ISDN GW 3241, Cisco TelePresence ISDN GW MSE 8321, Cisco TelePresence IP GW 3510, Cisco TelePresence MCU 4505, Cisco TelePresence Supervisor MSE 8050, Cisco TelePresence MCU MSE 8510 and Cisco TelePresence Advanced Media Gateway 3610 products.

Q. How do I adjust for daylight saving time changes on my Codian products?

A. Currently Codian equipment does not adjust for daylight saving automatically. You will need to adjust the time (or UTC offset, if using NTP) manually on your Codian equipment when time changes occur. Go to Settings > Time to do this.

Related Information

Revision History

Revision Publish Date Comments
1.0
30-Dec-2010
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco