Explore Cisco
How to Buy

Have an account?

  •   Personalized content
  •   Your products and support

Need an account?

Create an account

I installed a video camera to video input number 2 of my TANDBERG Codec using component video, now I'm not able to get any video when activating this source. Why?

Available Languages

Updated:April 23, 2015
Document ID:112629

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This article relates to Cisco TelePresence System Codec C90.

Q. I installed a video camera to video input number 2 of my TANDBERG Codec using component video, now I'm not able to get any video when activating this source. Why?

A. This answer is valid for the following products:

TANDBERG Codec C90

The TelePresence Product can connect up to 12 HD video input sources, but only five can be active simultaneously. As default the video input source number 2 is set to be HDMI.

To change this, open the Home menu on the TelePresence Product and go to: Settings > Administrator settings > Advanced configuration > Video > Input > Source 2 and set the Connector to YPbPr.

Related Information

Revision History

Revision Publish Date Comments
1.0
23-Apr-2015
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco