|
You use this page to update the firmware. You can perform the update
by browsing to a local drive or by using FTP to update the firmware
from a file server.
Settings
Manage Installation Keys --
Use this link to read specifications of the software license and
to install a new license.
Manage System Configuration
-- Use this link to restart the device, download a configuration
file, or reset settings to factory defaults.
Distribute
Configuration to other
Cisco Devices -- Use this link to send the device's configuration
to other Cisco Aironet devices on your network.
Distribute Firmware to
other Cisco Devices -- Use this link to send a new firmware
version to other Cisco Aironet devices on your network.
Hot Standby Management
-- Use this link to set up the standby device.
Cisco Discovery Protocol (CDP) --
Use this link to adjust the device's CDP settings.
Fully Update Firmware
These are links to alternative ways for reading and updating system
firmware, radio firmware, and web pages, all in one step.
Through
Browser -- With this method, you browse your hard drive
or mapped network drives to find the desired firmware and web page
files, and update all the firmware components at the same time.
From
File Server -- With this method, you enter named file
information to update all the firmware components at the same time.
Selectively Update Firmware
These are links to alternative ways for reading and updating system
firmware, radio firmware, and web pages. You can update the four
firmware components (the management system firmware, firmware web
pages, and radio firmware for both radios) individually or all at
once.
Through
Browser -- With this method, you to browse your hard
drive or mapped network drives to find the desired firmware and
web page files, and update firmware components individually.
From File
Server -- With this method, you enter named file information
to update firmware components individually.
Locate Unit by Flashing LEDs
Select Enabled and click Apply.
The bridge's top panel indicators blink in unison. You must select
Disabled and click Apply
to make the indicators stop blinking and return to normal operation.
| Command |
Description |
| Apply |
After entering new values for settings, click
Apply to activate the new settings. The browser remains on this page. |
| OK |
This button both applies the new settings and
moves the browser back to the previous page. |
| Cancel |
This button cancels all changes to the settings,
returns the settings to the previously stored values, and redirects
the use back to the previous stored entries. |
| Restore Defaults |
Click to change all settings on this page back
to the factory default settings. |
|
