Severity |
Event Description |
EMBLEM Mnemonic |
Possible Cause or Recommended Action |
Protocol Info |
Deauthenticating host, reason reason
host: host MAC address
reason: see Statuses
and Reasons
|
STA_DEAUTH |
None. |
Protocol Info |
Station host Authenticated
host: host MAC address |
STA_AUTH_OK |
None. |
Protocol Info |
Station host Associated
host: host MAC address |
STA_ASSOC_OK |
None. |
Protocol Info |
Station host Reassociated
host: host MAC address |
STA_REASSOC_OK |
None. |
Protocol Info |
Disassociating host, reason reason
host: host MAC address
reason: See Statuses
and Reasons
|
STA_DISASSOC |
None. |
Protocol Info |
Associate Response from Parent
host, status status
host: host MAC address
status: see Statuses
and Reasons
|
RCV_ASSOCRSP |
None. |
Protocol Info |
Unexpected Associate Response from host,
status status
host: host MAC address
status: see Statuses
and Reasons
|
RCV_ASSOCRSP_LATE |
None. |
Protocol Info |
Reassociate Response from Parent host,
status status
host: host MAC address
status: see Statuses
and Reasons
|
RCV_REASOC_RSP |
None. |
Protocol Info |
Unexpected Reassociate Response from host,
status status
host: host MAC address
status: See Statuses
and Reasons |
RCV_DISASSOC |
None. |
Protocol Info |
Disassociation from host, reason reason
host: host MAC address |
RCV_DISASSOC |
None. |
Protocol Info |
Deauthentication from host
reason reason
host: host MAC address |
RCV_DEAUTH |
None. |
Protocol Info |
Associated to Parent MAC address of AP |
PRNT_ASSOC |
None. |
Protocol Info |
Station host roamed host
host: host MAC address |
STA_ROAMED
|
None. |
Protocol Info |
Received Unexpected 802.11 Management packet from
host,
subtype=subtype, length=length
host: host MAC address
subtype: the 802.11 Frame Control subtype
length: the length of the 802.11 packet |
PRO80211_MNGPKT_LATE |
None. |
Protocol Info |
Station clientAddr User username
EAP-Authenticated
clientAddr: client MAC address
username: |
EAP_AUTH_OK |
Either the client device or the authentication
server might be misconfigured. Check the client and server configurations. |
Protocol Info |
Lost Association with Parent |
PRNT_ASSOC_LOST |
None. |
Protocol Info |
Disconnect remote user from ipAddr after exceeding
max number of login attempts
ipAddr: IP address of SSH client
|
SSHD_LOGIN_FAILED
|
None.
|
Port Info |
MAC-Address Authentication accepted for Station
clientAddr
clientAddr: client MAC address |
MACAUTH_OK
|
None. |
Port Info |
Attempting auto-negotiation to establish Ethernet
link |
ETHER_CON_FAILED
|
None. |
Port Info |
Started driver for port port
port: the network interface name, such as awc0 |
NET_DRV_START_OK |
None. |
Port Info |
Stopped driver for port port
port: the network interface name, such as awc0 |
NET_DRV_STOP_OK |
None. |
Port Info |
Bound name protocol to device device
name: name of protocol, such as IP 4.4 TCP/IP
device: the network interface device name, such as awc0 |
NET_BIND_PROT_OK |
None. |
System Info |
Hot Standby Enable failed
|
HSTNDBY_EN_FAILED |
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Hot Standby Disable failed
|
HSTNDBY_DIS_FAILED |
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Hot Standby Enabled successfully |
HSTNDBY_EN_OK |
None. |
System Info |
Hotstandby lost its association with monitored
AP |
HSTNDBY_ASSOC_LOST |
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Hotstandby lost its radio link to monitored AP |
HSTNDBY_RAD_LOST |
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Hotstandby lost its ether link to monitored AP |
HSTNDBY_ETH_LOST
|
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Failed in Turning off radio port when a Hot Standby
AP took over
|
HSTNDBY_RAD_OFF_
FAILED |
Power down root access point. |
System Info |
Hot standby AP is associated and the monitor starts
|
HSTNDBY_ASSOC_OK |
None. |
System Info |
Hot standby AP state indicates that the monitor
mode setup failed
|
HSTNDBY_MON_FAILED |
Verify root access point operation. |
System Info |
Hot Standby Disabled
|
HSTNDBY_DIS_OK
|
None. |
System Info |
HotStandby Failed to enable Hot Standby |
HSTNDBY_HSEN_FAILED |
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Hotstandby failed to set to the Active AP mode |
HSTNDBY_ACT_FAILED |
Verify hot standby and root access point configurations
match and the standby access point link test is successful.
|
System Info |
Hotstandby set to the Active AP mode |
HSTNDBY_ACT_OK |
None. |
System Info |
HotStandby starts to monitor the root AP |
HSTNDBY_STRT_MON |
None. |
System Info |
HotStandby stays as a client but stopped its protection |
HSTNDBY_STOP |
Start hot standby monitoring. |
System Info |
Turned command the media port
command: ON or OFF
media: Ethernet or Radio |
HSTNDBY_ONOFF
|
None. |
System Info |
Failed in turning command the media
port
command: ON or OFF
media: Ethernet or Radio |
HSTNDBY_ONOFF_FAILED
|
Verify the following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point link test is successful. |
System Info |
Turned off radio port because a Hot Standby AP
took over
|
HSTNDBY_RAD_OFF
|
None. |
System Info |
HotStandby Turning into hot standby mode |
HSTNDBY_TURN_ON |
None. |
System Info |
HotStandby starts to monitor the root AP |
HSTNDBY_STRT_MON |
None. |
System Info |
Hot standby AP is waiting for being associated
|
HSTNDBY_ASSOC_WAIT |
If no association within 30 seconds verify the
following:
Root access point operation.
Hot standby access point and root access point configurations
match.
The root and standby access point test is successful. |
System Info |
Successfully updated system firmware |
SYS_FW_UPD_OK
|
None. |
System Info |
RADIUS Accounting Start failed to get RADIUS ACCT
manager |
ACCT_CON_
FAILED
|
If this message appears continuously, reboot the
access point. |
System Info |
Acct request call back to NULL session |
AMNGR_REQ_NUL_SES |
None. |
System Info |
Acct request call back to NULL entry |
AMNGR_REQ_NUL_ENT
|
None. |
System Info |
Acct jobEntry time out on NULL session |
AMNGR_JE_NULL_SES |
None. |
System Info |
Acct jobEntry time out on NULL entry |
AMNGR_JE_NULL_ENT |
None. |
System Info |
Acct jobEntry time out when its manager is missing |
AMNGR_JE_TOUT |
None. |
System Info |
Acct entry creation fail due to NULL entry802_11 |
AMNGR_NEW_ENT_FAILED |
If this message appears continuously, reboot the
access point.
|
System Info |
Acct Stop could not find the AcctMgr |
AMNGR_STOP_NOMGR |
If this message appears continuously, reboot the
access point.
|
System Info |
Cannot stop ACCT due to session request failure |
AMNGR_SES_REQ_FAILED |
f this message appears continuously, reboot the
access point. |
System Info |
acctSessionFirst could not locate the AcctMgr |
AMNGR_SES1_NOMGR |
If this message appears continuously, reboot the
access point. |
System Info |
Acct Start could not find the AcctMgr |
AMNGR_START_NOMGR |
If this message appears continuously, reboot the
access point. |
System Info |
Cannot start ACCT due to session creation failure |
AMNGR_INIT_NOSES1 |
If this message appears continuously, reboot the
access point.
|
System Info |
Cannot start ACCT due to session request failure
|
AMNGR_INIT_NOSES2
|
If this message appears continuously, reboot the
access point.
|
System Info |
Acct session creation fail due to NULL ACCT manager |
AMNGR_SESFAIL_NOMGR |
If this message appears continuously, reboot the
access point. |
System Info |
Acct session creation fail due to NULL entry802_11 |
AMNGR_SESFAIL_NOENTRY |
If this message appears continuously, reboot the
access point. |
System Info |
Acct session creation fail at creating receive
RevBuffer
|
AMNGR_SESFAIL_NORBUF
|
If this message appears continuously, reboot the
access point. |
System Info |
Acct session creation fail at creating send Buffer |
AMNGR_SESFAIL_NOSBUF |
If this message appears continuously, reboot the
access point. |
System Info |
No ACCT Server configured for OPEN authenticated
client |
AMNGR_NOASERV_OPEN |
Accounting is enabled on the access point but
no accounting server is configured. Configure an accounting
server or, if a server is configured, check the server configuration. |
System Info |
No ACCT Server configured for SHAREDKEY authenticated
client |
AMNGR_NOASERV_SHARED |
Accounting is enabled on the access point but
no accounting server is configured. Configure an accounting
server or, if a server is configured, check the server configuration. |
System Info |
No ACCT Server configured for NETWORK_EAP authenticated
client |
AMNGR_NOASERV_EAP |
Accounting is enabled on the access point but
no accounting server is configured. Configure an accounting
server or, if a server is configured, check the server configuration. |
System Info |
Acct manager_c failed at creating MSG queue |
AMNGR_FAIL_QUE |
If this message appears continuously, reboot the
access point.
|
System Info |
Acct manager_c failed at launching its own task |
AMNGR_FAIL_TASK |
Reboot the access point.
|
System Info |
Acct manager_c received an ERROR from the queue
|
AMNGR_RCV_QERR |
If this message appears continuously, reboot the
access point. |
System Info |
Acct manager_c received a message for NULL session |
AMNGR_RCV_0SES_MSG
|
None. |
System Info |
RADIUS verification failed for Server server.
Probable shared secret mismatch
server: RADIUS server DNS name/IP address
|
AMNGR_RADAUTH_FAILED |
Check the accounting server configuration. |
System Info |
ACCT failed to send a message due to no configured
server |
AMNGR_SEND_FAILED_
NOSERV |
Disable accounting on the access point, or configure
an accounting server.
|
System Info |
BKeyXmit terminating BKeyRotation for vlanId vlanID.
vlanID: numeric VLAN identifier |
BKR_XMIT_VLAN_STOP |
None. |
System Info |
Bkey-MarkTime
|
BKP_MARK
|
None. |
System Info |
Ethernet Link Restored |
LOSS_ETHERNET_
RESTORED
|
None. |
External Info |
Detected probable reset of host host:host
MAC address
|
DDP_CLNT_RESET |
The access point believes that another infrastructure
device has restarted. If this message appears continuously,
reboot the access point. |