Protocol filters prevent or allow the use of specific
protocols through the interface. You can set up individual protocol
filters or sets of filters. This base page enables you to apply
the filters for incoming and outgoing Ethernet and 802.11b Radio
interfaces.
Filters must be created before they can be applied.
Click the MAC
Address Filters tab to create or edit filter indexes for MAC
addresses. Click the IP Filters
tab to create or edit protocol filters. Click the Ethertype
Filters tab to create or edit protocol filters.
Any filters you set on the MAC Address, IP Filters,
or Ethertype Filters pages are not applied until they are enabled
on this Apply Filters page. If clients are not filtered immediately,
click Reload on the System
Configuration page.
Incoming
From the drop-down menu, select the protocol
filter set that you want to enable for MAC, Ethertype, and IP.
Outgoing
From the drop-down menu, select the protocol
filter set that you want to enable for MAC, Ethertype, and IP.
See Also: Configuring
and Enabling Filters
|