This link leads to the Admin
Access screen where you can add users to and remove them from
the system and assign user capabilities.
Username
Displays the username of the active user.
Read-Only
Specifies whether the user has read-only capabilities.
Read-Write
Specifies whether the user has read/write capabilities.
This link leads to the SSID
Manager screen where you can specify authentication methods
and define VLANs.
SSID
Specifies the unique identifier the client devices
use to associate with the access point.
VLAN
Specifies the VLANs that are currently assigned.
Open/Shared/Network EAP
Specifies the method of authentication being used.
Open enables any bridge to authenticate and then attempt
to communicate with the access point. Shared sends an unencrypted
challenge string to any bridge attempting to communicate with the
access point. Network EAP uses EAP to interact with an EAP-compatible
server on your network to provide authentication for wireless client
devices.
On the AP1200 series, the encryption portion of
the Security screen is separated into its own screen. Click the
Radio0-802.11B Encryption Settings or Radio1-802.11A Encryption
Settings link to go to the WEP
Key Manager screen.
VLAN
Specifies the VLANs that are currently assigned.
Encryption Mode
Indicates whether clients should use data encryption
when communicating with the bridge. The options are None or WEP
Encryption.
MIC
Specifies whether MIC is enabled. WEP encryption
must be set to Mandatory for MIC to be enabled.
PPK
Specifies whether per packet keying is enabled.
With WEP key rotation enabled, the access point provides a dynamic
broadcast WEP key and changes it at the interval you specify.
TKIP
Specifies whether Cipher-TKIP is enabled.
WEP40bit
Specifies whether Cipher-WEP40BIT is enabled.
WEP128bit
Specifies whether Cipher-WEP128BIT is enabled.
CKIP
Specifies whether Cipher-CKIP is enabled.
CMIC
Specifies whether Cipher-CMIC is enabled.
This link leads to the Server
Manager page where you identify the remote servers to be used
for authentication.
Server Name/IP Address
Specifies the name or IP address of the server.
Type
Specifies the type of server.
EAP/Admin
Specifies what the server will be used for.
|