Table Of Contents
A - C - E - F - M - P - R - S - T - U - V -
Index
A
Allow TRAP Connections (port setting) 2-2
Answer Calls (port setting) 2-1
C
call information 1-1
CiscoUnified CM, supported versions for SIP trunk integrations 1-1
Cisco Unified CM 5.0
creating a new integration 3-8
phone system programming instructions 3-3
requirements 3-2
task list, creating a SIP trunk integration 3-1
Cisco Unified CM 5.1
creating a new integration 4-8
phone system programming instructions 4-3
requirements 4-2
task list, creating a SIP trunk integration 4-1
Cisco Unified CM 6.x
creating a new integration 5-8
phone system programming instructions 5-3
requirements 5-2
task list, creating a SIP trunk integration 5-1
Cisco Unified CM 7.x
creating a new integration 6-8
phone system programming instructions 6-3
requirements 6-2
task list, creating a SIP trunk integration 6-1
CiscoUnified CM Express, adding to a Cisco Unified CM integration A-1
CiscoUnified Survivable Remote Site Telephony (SRST) router, impact on integration 1-2
E
Enabled (port setting) 2-1
F
features provided by integration 1-2
forwarded calls, information sent by phone system 1-1
M
multiple integrations
about 1-3
adding new user template 8-1
P
Perform Message Notification (port setting) 2-2
phone systems, supported for SIP trunk integrations 1-1
ports
planning how many will answer calls 2-2
planning how many will dial out 2-3
planning number to install 2-2
planning setup 2-1
settings 2-1
R
RDNIS, impact of non-deliver on integration 1-2
S
Send MWI Requests (port setting) 2-2
SRST, impact on integration functionality 1-2
supported phone systems 1-1
T
template, adding a new user template for multiple integrations 8-1
testing
deleting the test user 7-4
setting up supervised transfer 7-3
setting up test configuration 7-1
testing an external call with release transfer 7-2
testing supervised transfer 7-4
testing the functionality for listening to messages 7-3
U
user template, adding new for multiple integrations 8-1
V
voice messaging ports, settings 2-1