F Commands

This chapter describes the Cisco NX-OS PIM commands that begin with F.

feature pim

To enable Protocol Independent Multicast (PIM), use the feature pim command. To disable PIM, use the no form of this command.

feature pim

no feature pim

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

Global configuration mode

Command History

Release
Modified

5.2(1)N1(1)

This command was introduced.


Usage Guidelines

You must enable the PIM feature before you can configure PIM.

This command requires the LAN Base Services license.

Examples

This example shows how to enable a PIM configuration: 

switch(config)# feature pim 

switch(config#

 
   
 
    
   
 Related Commands
 
   
 
    
 
      
      
      
 
        
        

          Command 
        
 		 
        
        

          Description 
        
 		 
      
 
      
 
       
 show running-configuration pim 
 		 
       
 Displays the PIM running configuration information. 
 		 
      
 
      
 
       
 show feature 
 		 
       
 Displays the status of features on a switch. 
 		 
      
 
      
 
       
 ip pim sparse-mode 
 		 
       
 Enables IPv4 PIM sparse mode on an interface.