Cisco Nexus 3000 Series NX-OS Multicast Configuration Guide, Release 5.0(3)U4(1)

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: July 13, 2011

Chapter: New and Changed Information

New and Changed Information

This chapter provides release-specific information for each new and changed feature in the Cisco Nexus 3000 Series NX-OS Multicast Routing Configuration Guide, Release 5.0(3)U4(1). The latest version of this document is available at the following Cisco website:

http://www.cisco.com/en/US/products/ps9670/products_installation_and_configuration_guides_list.html

To check for additional information about this Cisco NX-OS Release, see the Cisco Nexus 3000 Series Switch NX-OS Release Notes, available at the following Cisco website:

http://www.cisco.com/en/US/products/ps9670/prod_release_notes_list.html

summarizes the new and changed features for the Cisco Nexus 3000 Series NX-OS Multicast Routing Configuration Guide, and tells you where they are documented.

Table 1 New and Changed Features
Feature	Description	Changed in Release	Where Documented
Disabling Multicast Multipath	You can disable the automatic selection that allows you to specify a single RPF interface for multicast.	5.0(3)U4(1)	Configuring PIM
PIM Register Messages	You can use the ip pim register-source command to configure the IP source address of register messages when the IP source address of a register message is not a uniquely routed address to which the RP can send packets.	5.0(3)U4(1)	Configuring PIM
MSDP	You can enable the remote multicast source support to redirect traffic.	5.0(3)U2(1)	Configuring MSDP
IGMP	You can configure the switch to use the general Maximum Response Time (MRT) in response to an IGMP global leave message for general queries.	5.0(3)U1(2)	Configuring IGMP
PIM	You can prevent duplicate packets in the hardware when the transition from RPT to SPT is in progress.	5.0(3)U1(2)	Configuring PIM

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)