Your software release may not support all the features documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the Feature Information Table at the end of this document.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to
www.cisco.com/go/cfn. An account on Cisco.com is not required.
Custom Queueing Configuration Task List
You must follow certain required, basic steps to enable CQ for your network. In addition, you can choose to assign packets to custom queues based on protocol type, interface where the packets enter the router, or other criteria you specify.
CQ allows a fairness not provided with priority queueing (PQ). With CQ, you can control the available bandwidth on an interface when it is unable to accommodate the aggregate traffic enqueued. Associated with each output queue is a configurable byte count, which specifies how many bytes of data should be delivered from the current queue by the system before the system moves on to the next queue. When a particular queue is being processed, packets are sent until the number of bytes sent exceeds the queue byte count defined by the
queue-listqueuebyte-count command (see the following section
Specifying the Maximum Size of the Custom Queues), or until the queue is empty.
To configure CQ, perform the tasks described in the following sections.
Specifies the maximum number of packets allowed in each of the custom queues. The limit-number argument specifies the number of packets that can be queued at any one time. The range is from 0 to 32767. The default is 20.
Designates the average number of bytes forwarded per queue. The byte-count-number argument specifies the average number of bytes the system allows to be delivered from a given queue during a particular cycle.
Establishes queueing priorities based on the protocol type.
All protocols supported by Cisco are allowed. The queue-keyword
variable provides additional options, including byte count, TCP service and port number assignments, and AppleTalk, IP, IPX, VINES, or XNS access list assignments.
When you use multiple rules, remember that the system reads the queue-list commands in order of appearance.