Domain ID field
|
The
virtual port channel (vPC) domain ID used to create a vPC domain.
|
Source Management IP Address field
|
The IP
address for source management.
|
Destination Management IP Address field
|
The IP
address for destination management.
|
Role Priority field
|
The
role priority within the valid range for this vPC switch. The default value is
32667. The switch with a lower priority is elected as the vPC primary switch.
If the peer link fails, vPC peer detects whether the peer switch is alive
through the vPC peer keepalive link. If the vPC primary switch is alive, the
vPC secondary switch suspends its vPC member ports to prevent potential looping
while the vPC primary switch keeps all its vPC member ports active.
|
System Priority field
|
The
system priority within the valid range for the specified vPC domain. The
default value is 32667. You should manually configure the vPC system priority
when you are running the Link Aggregation Control Protocol (LACP) to help
ensure that the vPC peer devices are the primary devices on LACP. When you
manually configure the system priority, make sure that you configure the same
priority value on both vPC peer devices. If these values do not match, then the
vPC is not activated.
|
Delay Restore field
|
Specify the time (in number of seconds) to delay bringing up the
restored vPC peer device. The range is from 1 to 3600.
|
Peer Gateway check box
|
Check this box to enable Layer 3 forwarding for packets destined
to the gateway MAC address of the virtual Port Channel (vPC).
|
Auto Recovery check box
|
Check this box to enable virtual Port Channel (vPC) auto-recovery feature on the network device.
|
Copy Running configuration to Startup configuration
check box
|
Check
the check box to copy the running configuration to the startup configuration.
|