Cisco Nexus 6000 Series NX-OS System Management Command Reference
A Commands
Downloads: This chapterpdf (PDF - 82.0KB) The complete bookPDF (PDF - 1.17MB) | Feedback

A Commands

Table Of Contents

A Commands

abort (session)

acllog match-log-level


A Commands


This chapter describes the system management commands that begin with A.

abort (session)

To discard the current configuration session, use the abort command.

abort

Syntax Description

This command has no arguments or keywords.

Command Default

None

Command Modes

Session configuration mode

Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.


Examples

This example shows how to abort the current configuration session:

switch# configure session MySession1 
switch(config-s)# abort 
switch# 
 
   

Related Commands

Command
Description

commit

Commits a session.

configure session

Creates a configuration session.

show configuration session

Displays the contents of the session.

verify

Verifies a session.


acllog match-log-level

To specify the minimum severity level to log ACL matches, use the acllog match-log-level command. To remove the acllog match log level, use the no form of this command.

acllog match-log-level severity-level

no acllog match-log-level severity-level

Syntax Description

severity-level

Number of the desired severity level at which messages should be logged. Messages at or numerically lower than the specified level are logged. Severity levels are as follows:

0—emergency: System unusable

1—alert: Immediate action needed

2—critical: Critical condition

3—error: Error condition

4—warning: Warning condition

5—notification: Normal but significant condition—default level

6—informational: Informational message only (default)

7—debugging: Appears during debugging only


Command Default

None

Command Modes

Global configuration mode

Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.


Examples

This example shows how to set the acllog match-log-level to 6, informational:

switch(config)# acllog match-log-level 6
switch(config)# 
 
   

Related Commands

Command
Description

logging level

Enables logging messages from a specified facility and configures the logging severity level.

logging logfile

Configures the name of the log file used to store sytsem messges and sets the minimum severity level to log.