The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS virtual port channel (vPC) commands that begin with F.
To enable a virtual port channel (vPC), which allows links that are physically connected to two different Cisco Nexus 5000 Series devices to appear as a single port channel to a third device, use the feature vpc command. To disable vPC on the switch, use the no form of this command.
feature vpc
no feature vpc
This command has no arguments or keywords.
Disabled
Global configuration mode
|
|
---|---|
5.2(1)N1(1) |
This command was introduced. |
In a vPC configuration, the third device can be a Cisco Nexus 2000 Series Fabric Extender, switch, server, or any other networking device.
This example shows how to enable vPC on the switch:
switch(config)# feature vpc
|
|
---|---|
show vpc |
Displays the vPC configuration status. |
show feature |
Displays whether or not vPC is enabled on the switch. |