Table Of Contents
Cisco 1805 DOCSIS 2.0 Cable Router
Quick Start Guide
This document lists where you can find detailed documentation for further installation, configuration and initial steps for connecting the Cisco 1805 Data-over-Cable Service Interface Specifications (DOCSIS) 2.0 Cable Router.
•Connect the Router
To access the Cisco 1805 DOCSIS 2.0 cable router product documentation, access this URL:
You can access other current Cisco documentation at this URL:
Connect the Router
To set-up and connect your router, follow these steps:
Step 1 Verify that the following items were shipped with your router:
Step 2 To connect up to four PC to the router, connect the Ethernet cable from the Ethernet switch ports to the PC.
Step 3 To configure the router through the Cisco IOS command-line interface (CLI), connect the router console port to a terminal or PC.
Step 4 To connect to an ISP, attach one end of the cable adapter to the Cisco cable modem HWIC (high-speed WAN interface card) and the other to the cable source.
Step 5 Connect the power cord as shown. Move the power switch to the ON position.
The following indications appear:
•The green SYS PWR LED on the front of the chassis lights up.
•The fan operates.
Step 6 Log on to your router through the console port and use the CLI to configure your router.
For detailed information about how to install and configure your router, see the following documentation:
•Regulatory Compliance and Safety Information for Cisco 1840 Routers
•Cisco 1805 DOCSIS 2.0 Cable Router Hardware Installation Guide
•Cisco 1800 Series Software Configuration Guide
•Cisco IOS software documentation, all releases
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2007 Cisco Systems, Inc. All rights reserved.
Printed in the USA on recycled paper containing 10% postconsumer waste.