Cisco Network Analysis Module for Nexus 1010 4.2 Installation and Configuration Guide
Troubleshooting
Downloads: This chapterpdf (PDF - 331.0KB) The complete bookPDF (PDF - 1.34MB) | Feedback

Troubleshooting

Table Of Contents

Troubleshooting

Resetting the NAM Password


Troubleshooting


This chapter describes some common problems that occur while setting up the Cisco Nexus 1000V NAM Virtual Service Blade.

Resetting the NAM Password

Resetting the NAM Password


Step 1 From the NAM CLI, execute this command:

reboot -helper

Step 2 You will be prompted for Y/N verification that you want to reboot. Click Y, and the NAM will boot into the helper image and display the menu.


=====================================================
Cisco Systems, Inc.
Network Analysis Module (NAM) helper utility
Version 4.2(1) 

-----
Main menu
1 - Download application image and write to HDD
2 - Download application image and reformat HDD
3 - Install application image from CD
4 - Display software versions
5 - Reset application image CLI passwords to default
6 - Change file transfer method (currently ftp/http)
7 - Send Ping
n - Configure network
r - Exit and reset Services Engine
h - Exit and shutdown Services Engine Selection [1234567nh]: 


Step 3 At the helper menu, pick 5, "Reset application image CLI passwords to default."

Step 4 Click r to reset the NAM.

Step 5 After the NAM boots back up, you will need to reset the default password when logging in as root.